7
8. On the laptop, move the cursor to the
Odometer Value box.
Select it.
9.
Enter the Water Meter Transmitter
Serial Number into the Odometer Value
box.
NOTE:
Do not enter the leading 7 of the
Transmitter Serial Number.
10. Place the Optical Programmer onto the
Programming Accessory or insure it is
still connected.
11. Select
[Program Odometer] button.
12. A screen appears saying,
The meter type is UNKNOWN.
Select OK.
13. Swipe the programming magnet over
the bottom right corner of the ORION
®
Repeater to put the unit into
programming mode. Once the ORION
Repeater has been put into
programming mode, it will listen for a
signal from the Programming Accessory
for up to 16 seconds. Once it
successfully hears the Programming
Accessory signal, the ORION Repeater
will verify it has been successfully
programmed by continuously
broadcasting the ORION transmitter
reading for one minute.
14. As soon as you are done programming
an ORION Repeater, it is important to
turn off your Programming Accessory.
Turn off the Programming Accessory by
properly positioning the Optical
Programmer on to the Programming
Accessory and selecting the
[Stop
Radio]
button.
NOTE: To erase all ORION serial
numbers in the repeater, program the
Program Accessory to a transmitter
number of ‘0’ and place the ORION
Repeater in programming mode using
the steps above.
