CXX-UM-01850-EN-01
SPECIFICATIONS
Frequency
32-point linearization curve of frequency/viscosity versus counts per units measured by interpolation between
points and, by extrapolation, from the first and last two points of the curve An engineering factor is included for
the conversion of units
Oange
0 5 Hz…65 kHz
Signal Conditioning
Standard
TTL type signal input or voltage pulse
Optional
Reed switch: sine wave, low level input to base of PNP transistor
and two-wire modulated current frequency inputs
Sensor Excitation Voltage
Standard
12V DC
Optional
User adjustable, 1 5…24V DC
Analog Inputs
Inputs
5-point linearization; 4…20 mA or 0…10V DC
Oesolution
16-bit
Accuracy
± 0 001% of full scale
Analog Outputs
Outputs
4…20 mA or 0…10V DC
Oesolution
16-bit
Accuracy
± 0 001% of full scale ± least significant digit
Pulse Outputs
TTL or open collector outputs with a range of 1 Hz…1 kHz
Oelays
0 25A at 240V AC, 9 (dry relay)
Power Supply
Mains input or DC input; 110/240V AC is selectable on a switch inside the computer
220…240V AC, 50…60 Hz
Draws approximately __ mA (Depends on options fitted)
110…120V AC, 50…60 Hz
Draws approximately __ mA (Depends on options fitted)
12V DC
Draws approximately __ mA (Depends on options fitted)
24V DC
Draws approximately __ mA (Depends on options fitted)
ALTHOUGH THE EQUIPMENT HAS PROTECTION AND CONFORMS TO CE APPROVALS, FOR TROUBLE FREE OPERATION
THE COMPUTER SHOULD BE CONNECTED TO A CLEAN POWER SUPPLY – MEANING FREE OF NOISE AND NOT IN THE
SAME PHASE AS HEAVY MACHINERY.
ANY MACHINERY USING HEAVY CONTACTS IN THE IMMEDIATE PROXIMITY OF THE COMPUTER SHOULD BE SUITABLY
SUPPRESSED. INDUCTIVE LOADS SWITCHED BY THE VOLT-FREE RELAY CONTACTS SHOULD BE FITTED WITH SUITABLE
SNUBBER NETWORKS.
Specifications
Page 30
February 2018
