ASSEMBLING THE BASSINET:
STEP 1:
Insert the BASSINET BOTTOM PANEL (A) into the BASSINET FRAME WITH
BEDDING (B) with the white side of the bottom panel facing up. Insert the TWO 1”
CARRIAGE BOLTS through the BOTTOM PANEL and the fabric and secure to the WOOD
SUPPORT BAR (D) with TWO 1/4” ACORN NUTS (E). Tighten the nuts well, but don’t over-
tighten. See PICTURES 1A and 1B.
STEP 2:
At the foot end of the bassinet, insert ONE 1-1/4” CARRIAGE BOLT (F) through the
hole on the metal tube of the BASSINET FRAME (A) and then through the top hole on one
PLASTIC LEG (G). Secure the bolt with ONE WASHER (H) and ONE 1/4” ACORN NUT (E).
Tighten securely but don’t overtighten. See PICTURES 2A and 2B.
STEP 3:
Repeat Step 2 for the opposite side of the bassinet (the end where the hood is
attached). Before you tighten the WASHER (H) and ACORN NUT (E) slip the edge of the fabric
hood between the BASSINET FRAME (A) and the PLASTIC LEG (G). See PICTURE 3.
STEP 4:
Line up the WOOD SUPPORT BAR (D) with the middle hole on the PLASTIC LEG
(G) (you can do either side of the bassinet first). Take ONE METAL SUPPORT RAIL (I), ONE
2” HEX HEAD SCREW (J), and the HEX HEAD WRENCH (K). Secure wood support bar,
metal support rail, and plastic leg together with the 2” HEX HEAD SCREW (J). See PICTURES
4A and 4B .
STEP 5:
Repeat Step 4 on the opposite side of the bassinet with the second metal support rail.
STEP 6:
Insert ONE 1/2” HEX BOLT (L) through the METAL SUPPORT RAIL (I) and the
bottom hole on the PLASTIC LEG (G). Secure with ONE 1/4” ACORN NUT (E). See
PICTURE 5.
STEP 7:
Repeat Step 6 for the metal support rail on the opposite side.
STEP 8:
If not already done, put the BASSINET SHEET (M) onto the MATTRESS PAD (N).
Put the pad with sheet into the bassinet.
Your bassinet is now ready for use! Suitable for use until Baby is 16 lbs (7.27 kg) or until Baby
is able to roll over unassisted and/or push up on hands and knees. The fabric can be spot cleaned
with warm water and a mild detergent if needed.
Page 2 of 4 1.1/0604
