1.2/0407/TG
Page 4 of 5
PICTURE 7C
PICTURE 8
STEP 6
- PICTURE 6
:
Attach the SECOND
END PANEL (B1) to the
TWO TOP RAILS (E)
and SIX SHELF RAILS
(F) using EIGHT 1¾”
BOLTS (G).
STEP 7 - PICTURES 7A,
7B and 7C
:
Note: This step can
also be completed with the
table upside down to make
it easier.
See PICTURE
7A. Slip one end of the
SAFETY BELT (I)
between the TOP RAIL
(E) and the TOP SHELF
RAIL (F).
H
PICTURE 5
B2
H
H
B1
PICTURE 6
PICTURE 7B
I
F
E
J
E F
I
H
PICTURE 7A
See PICTURE 7B. Using the pre-made hole on the
SAFETY BELT (I) and the pre-drilled hole on the
underside
of the TOP SHELF RAIL (F), sandwich the
end of the SAFETY BELT (I) between the METAL
SUPPORT BAR (J) and the top shelf rail as shown and
secure with ONE 5/8” SCREW (K).
See PICTURE 7C. Secure the other end of the
SAFETY BELT (I) and the other end of the METAL
SUPPORT BAR (J) using the second 5/8” SCREW
(K).
STEP 9
-
PICTURE 9
: Insert the METAL PINS (M), and the wooden pegs, on the LEFT (N) and RIGHT SIDE
PANELS (O) into the holes on the side edges of the BACK PANEL (P). Be sure all of the shelf grooves are lined up.
Insert TWO ROUND METAL CAMS (Q) into the holes on the BACK PANEL (P) with the arrows on the cams
pointing towards the heads of the metal pins. Turn the cams clockwise using a standard screwdriver until they lock over
the heads of the pins. Insert the BOTTOM PANEL (R) into the grooves and be sure it’s seated on all three sides.
STEP 10 - PICTURE 10
: Repeat the pin and cam procedure from Step 9 to attach the FRONT PANEL (S) to the
LEFT (N) and RIGHT SIDE PANELS (O). Be sure the BOTTOM PANEL (R) is properly seated in the grooves on all
four sides.
STEP 11 - PICTURE 11
: With the drawer upside down, attach the TWO INSIDE DRAWER TRACKS (T1 and T2) to
the SIDE PANELS (N, O) using the pre-drilled holes and THREE ½” SCREWS (C) for each track. The wheels on the
tracks line up with the back edge of the drawer.
STEP 8 -
PICTURE 8
:
NOW YOU
WILL ASSEMBLE THE DRAWER!
Take the FOUR METAL PINS
(M) and screw them into the
pre-installed threaded plastic jackets on
drawer parts N, O, and S. Screw in the
pins only as deep as their threads.
