2.0/1008/TG
Page 5 of 6
PICTURE 8
H1
PICTURE 5
B2
H2
B1
PICTURE 6
STEP 6
- PICTURE 6
: Attach the SECOND END PANEL (B1) to the TWO TOP RAILS (E) and SIX SHELF RAILS
(F1, F2) using EIGHT 1¾” BOLTS (G).
STEP 7 - PICTURES 7A, 7B and 7C
:
Note: This step can also be completed with the table upside down to make it easier.
See PICTURE 7A. Slip one end of the SAFETY BELT (I) between the TOP RAIL (E) and the TOP SHELF
RAIL (F1).
See PICTURE 7B. Using the pre-made hole on the SAFETY BELT (I) and the pre-drilled hole on the
underside
of
the TOP SHELF RAIL (F1), sandwich the end of the SAFETY BELT (I) between the METAL SUPPORT BAR (J) and the
top shelf rail as shown and secure with ONE 5/8” SCREW (K).
See PICTURE 7C. Secure the other end of the SAFETY BELT (I) and the other end of the METAL SUPPORT BAR
(J) using the second 5/8” SCREW (K).
STEP 8 -
PICTURE 8
:
NOW YOU WILL ASSEMBLE THE DRAWER!
Take the FOUR METAL PINS (M) and screw them into the pre-installed threaded plastic jackets on drawer
parts N, O, and S. Screw in the pins only as deep as their threads.
H2
PICTURE 7C
PICTURE 7B
I
E
J
E F1
I
H1
PICTURE 7A
F1
*You must be sure to
use the thicker H1
shelf in the top
position.