Bad Boy MZ 42", Owner'S, Service & Parts Manual

Page: 8 / 56

2.69 Always maintain the correct tire pressure. Do not inflate the tires above the recommended pressure. Never weld or heat a wheel
and tire assembly. The heat can cause an increase in air pressure resulting in a tire explosion. Welding can structurally weaken
or deform the wheel.
2.70 Park machine on level ground. Never allow untrained personnel to service machine. Understand service procedure before
doing work.
SAFETY INTERLOCK SYSTEM
Your Bad Boy mower is equipped with a safety interlock system. This system is designed to prevent serious injury or death to the
operator and other people or property damage. The system consists of an operator presence switch in the seat, the parking brake,
drive lever neutral position, the mower blade engagement switch, and the ignition switch.
These interlocks are vitally important and must be tested frequently. Following are instructions to test these very important safety
precautions.
Note: the operator must be seated properly on the machine during these tests and the engine should
have been previously allowed to warm to operating temperature.
2.71 With the parking brake engaged, bring lever arms to their inward position, then attempt to start the machine (the blade actuator
should be in off position); the engine should not start.
2.72 On a level surface, disengage the parking brake and place lever arms to their outward position, then attempt to start the
machine (the blade actuator should be in off position); the engine should not start.
2.73 Engage parking brake and leave lever arms in outward position, put blade actuator in the on position, then attempt to start the
machine; the engine should not start.
2.74 Next, start the engine as stated in the “Mower Operation Section”, disengage parking brake, and Very Slowly begin to rise from
the seat; the engine should stop.
If any of these tests fail to produce the results indicated and the problem cannot be identified, contact your Bad Boy Mower
dealer or the support contacts in the rear of this manual.
PAGE 8