PAGE 95
REASSEMBLY
• Install the bearing.
• Install the snap
ring with snap ring
pliers.
Left Crankcase Cover:
• Remove the oil
pressure valve.
• When installing the
oil valve, tighten
it to the specified
torque.
• Oil pressure
value:25N:
M(2.5kgf-m,17lb-ft)
• Using a tool, check
the oil pressure
valve operation. If
the piston does not
operate, replace it.
ASSEMBLY
• Remove the oil seal.
REASSEMBLY
• Install the bearing.
• Apply Grease to the
bearing,O-ring and
Oil seal lip.
• Install the oil seal.
NOTE:
When installing the
oil seals, be sure the
stamped mark on the
oil seal faces outside.
• Apply a small
amount of
Locktite 262TM
(Thread locker)
to the screws and
install the bearing
retainer.
Summary of Contents for 1500
