Backyard Discovery Mountaineer, Assembly Instructions Manual

Page: 34 / 35

Single Beam
Phase 4
Step 1: Gather assembly from phase 3 & hardware bag.
Step 2: Slide top beam into clamp on fort and attach with 5/16"x6" carriage bolts as shown in fig. 1 below.
Step 3: Adjust the single beam legs to make sure the top beam is level. Legs may be taken
in or out to adjust on uneven ground.
Step 4: Once top beam is level, secure legs using (8) 5/16"x2 1/2" lag screws per single beam
clamp as shown below.
Step 5: Attach support brace B to legs with (2) 4 1 /2" lag screws and (2) flat washers.
Step 6: Place double angle gussets G against beam and cross brace & attach with (4) 4 1/2" lag screws
and 5/16" washers as shown in Fig G.
NOTE: Do not allow metal plate to extend
- past the legs at minimum distance.