Backyard Discovery 2304079, Manual

Page: 149 / 170

Prepare the Gas Supply
1. Open the hood completely. Do not light burners with the
hood closed.
2. Make sure control knobs are turned to OFF. The drip tray
must be in place and pushed all the way to the
back.
A. Drip tray
WARNING: If the burner still does not light, turn the
burner control knob to OFF and wait five minutes
to let the gas clear before you try again or try to
light with a match.
3. For outdoor grills using a 20 lb LP gas fuel tank: Slowly
open the tank valve.
NOTE: If flow limiting device activates, your grill may not
light. If your grill does light, the flames will be low and
will not heat properly. Turn tank valve and all control
knobs off and wait 30 seconds. After shutting off the tank,
very slowly open tank valve and wait 5 seconds before
lighting. Main Burner Ignition:
Always open the lid before igniting the burners.
4. Each control knob will create its own spark. Push the control
knob in and turn to + position.
5. Cont i nue to hold the knob in for a few seconds to allow gas
to flows thr ough the tube . Y ou will hear a "snap" from the
igniter as a spark ignites to the burner lighting tube. You will
also see 3"-5" of orange flame coming from the burner lighting
tube.
6. Check that the burner is lit by looking through the cooking
grate. You should see a flame. If burner does not light on first
try, push control knob in and turn it to OFF position. Repeat
lighting procedure.
Fire Hazard
!
!
WARNING
Main Burner Ignition
Manually Lighting the Main Grill
1. Do not lean over the grill.
2. Make sure all burner control knobs are turned off. Push each
knob in and turn it clockwise to ensure it is in the OFF
position.
3. Open the lid. Remove the manual lighting extension from
underneath grill cabinet, attached to upright tube (see
following illustration) and attach a match to the split ring.
4. With match attached to split ring, strike match.
5. Insert matchstick holder and lit match down through cooking
grates to ignite the selected burner.
6. Push the control knob in and turn it to + position.
7. Check that the burner is lit by looking through the cooking
grates; you should see a flame.
8. Repeat steps 2 through 7 for each main burner.
9. Remove match and replace the manual lighting extension on
the upright tube.
IMPORTANT:
If burner does not light immediately, turn the burner knob to OFF
and wait 5 minutes before relighting.
If any burners do not light after attempting to light them manually,
contact the Customer Service Center. See the "Assistance" section.
Warning (After use):
Storage of an outdoor cooking gas appliance indoors is permissible
only if:
The cylinder is disconnected and removed from the outdoor
cooking gas appliance.
TO EXTINGUISH:
Push in and turn each burner control knob clockwise to OFF
position. Turn gas supply off at source when finished.
TO EXTINGUISH:
Push in and turn each burner control knob clockwise to OFF
position. Turn gas supply off at source when finished.
22