Important Assembly Notes
1) While assembling unit, take time before and after each step to make sure unit is level. If unit is
not level, assembly will be difficult and improper assembly may result. Extra care must be taken to
ensure the unit is square.
2) Pay close attention to the ITEMS NEEDED FOR EACH STEP. They can be a valuable aid when
sorting your wood and hardware. Assembly will be made easier if items are sorted by step.
3) Pay close attention to make sure you are using the correct hardware in the correct steps. Using
incorrect hardware may result in improper assembly.
4) Whenever a T-nut is used, follow these directions. Place T-nut in pre-drilled hole. Tap in with hammer.
Place bolt with washers in the opposite side. Hand tighten to make sure the bolt is in the T-nut.
DO NOT over tighten.
5) Read any written steps of each step thoroughly. The written steps may include important information not
shown in the illustrations.
Basic Setup Dimensions
Place the set on level ground, not less than 6 ft [2 m] from any structure or obstruction such
as a fence, garage, house, overhanging branches, laundry lines, or electrical wires.
6'-0"
6'-0"
12'-0"
10'-0"
7'-11 1/16"
6'-7 1/2"
8'-11 3/8"
120.79
6'-11 3/8"
8'- 3/4"
GENERAL INFORMATION:
YOUR PERGOLA HAS BEEN DESIGNED
AND ENGINEERED FOR RESIDENTIAL
USE ONLY. A MAXIMUM WEIGHT LIMIT
OF 600 POUNDS IS RECOMMENDED
FOR THE BENCH.
