BNK00417K01
Figure 1
Figure 2
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE KEEP INSTRUCTION SHEET, WARRANTY CARD, AND RECEIPT.
Page 2
* NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE
Step 4:
Note:
Do not over tighten
After making any necessary adjustments to the
alignment of the table, use the hex bolt driver and hex
wrench to tighten all bolts and nuts.
each bolt
must be tightened a few revolutions at a time. In order
to apply equal pressure to all bolt joints, we recommend
working in a cross corner (X fashion). Repeat until all
bolts are tight.
. Over tightening
may strip bolts. Cover all nuts with covers.
With the help of another person, turn the table in the
upright position. Your table is now ready for use. If you
have any questions, please call our Customer Service
Center at 1-800-416-3511.
Step 5:
IMPORTANT NOTE: Damage to welds or frames resulting
from over tightened bolts or improper assembly is not covered
under our warranty. Please read all instructions carefully
before assembly. If you have any questions regarding your
assembly, call our Customer Service Center at 1-800-416-3511.
Step 1:
Do not attempt
assembly if any parts are missing or damaged.
Remove all protective materials and set parts on a flat,
non-abrasive surface. Identify parts packed in carton
against the parts list. If you are missing any parts or
unsure how to proceed with assembly, call our Customer
Service Center at 1-800-416-3511.
Step 2:
Hand tighten only 2-3 turns.
Attach a leg to the table top by using two
bolts and washers as shown in
. Guide the bolts
through the holes in the legs into the pre-drilled holes in
the table top.
Repeat for
the other legs.
F
1
Place the table top upside down on a flat, non-abrasive
surface.
igure
Ø
X
20
Ø6.5 X 2.0 MM
WASHER
HW0594
8
PARTS LIST
DESCRIPTION
ORDER PART # QTY
1
A
B
C
D
E
F
G
H
I
J
K
1
HEX BOLT DRIVER
HW0004
HW0006
FOOT CAP
FACTORY ASSEMBLY
4
Ø6.5 X 1.0 MM
WASHER
FC0607
16
1/4" X 35 MM BOLT
HW0142
8
2
TABLE LEG
LEG CONNECTOR
BRACKET
TABLE TOP
HW0027
16
HEX WRENCH
HW0009
NUT COVER
1
HW0014
1/4" NUT
16
UMBRELLA HOLE
PROTECTIVE RING
FACTORY ASSEMBLY
G0175
FOOT CAP
F
D
E
G
H
E
G
H
B
A
C
BAR HEIGHT
EXTENSION POLE
AT52107
1
Step 3:
Attach a leg connector bracket to the table legs by
guiding the bolts that are preassembled in the table legs
(each leg has two bolts) through the holes in the leg
connector bracket. Add a Ø6.5 X 1.0 mm washer and
a nut to the end of each bolt as shown in
.
Repeat for the other leg
connector bracket.
F
2
Hand tighten only 2-3 turns.
igure
ST0955
ST0956
ST0957