FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
4
4
4
4
4
4
2
2
13
11
12
10
4
4
4
4
2
1
1
1
1
4
4
4
2
4
Step 2:
Insert bolt (#10) with washer (#12) through the outside
bottom support (#4). Then, place washer (#11) onto the
bolt and insert through the inside bottom support (#4).
Place a plastic end cap (#13) onto the bolt and screw into
the cross brace (#2). Repeat the same procedure for both
sides. See Figure 2.
Note:
The labelled arrows on the bottom supports (#4) should
be facing each other as displayed in Figure 1.
Step 1:
Position two bottom supports (#4) together facing in
opposite directions. See Figure 1.
Step 3:
Secure the safety locks on all sides of the bottom
supports (#4). See Figure 3.
Step 4:
Press the spring buttons on the bottom supports (#4)
and insert into the side supports (#1). Make sure that the
spring buttons on the bottom supports (#4) come
completely through the holes on the side supports (#1).
See Figure 4.
2
