Backyard Creations 259-5091, Manual, Page: 9 / 14

9
OPERATING INSTRUCTIONS
LEAK TEST
1. Make 2-3 oz. of leak test solution (one - part liquid dishwashing detergent to
three parts water).
2. Apply several drops of solution where hose attaches to regulator.
3. Apply several drops of solution where regulator connects to cylinder.
4. Make sure all patio heater valves are OFF.
5. Turn cylinder valve ON.
IF BUBBLES APPEAR AT ANY CONNECTION, THERE IS A LEAK.
1. Turn cylinder valve OFF.
2. If leak is detected at hose/regulator connection, tighten connection and perform another leak test. If bubbles continue to
appear, c ontact customer service at cservice@welltraveled.net .
3. If leak is detected at regulator/cylinder valve connection, disconnect, reconnect, and perform another leak test. If you
continue to see bubbles after several attempts, cylinder valve is defective. Contact customer service at
cservice@welltraveled.net .
IF NO BUBBLES APPEAR AT ANY CONNECTION, THE CONNECTIONS ARE SECURE.
Note: Whenever gas connections are loosened or removed, you must perform a complete leak test.
Caution: Do not attempt to operate this appliance until you have read and
understand all Safety Information in this manual and all assembly is complete and
leak tests have been performed.
BEFORE TURNING GAS SUPPLY ON:
1. Your heater was designed and approved for OUTDOOR use only. Do NOT use it
inside a building, garage, or any other enclosed area.
2. Make sure surrounding areas are free of combustible materials, gasoline, and other
flammable vapors or liquids.
3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections are
tight and there are no leaks.
4. Be sure the cylinder cover is clear of debris. Be sure any component removed during assembly or servicing is replaced and
fastened prior to starting.
BEFORE LIGHTING:
1. Heater should be thoroughly inspected before each use, and by a qualified service person at least annually. If re-lighting a
hot heater, always wait at least 5 minutes.
2. Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear. Suspected areas should be leak tested. If the
hose leaks, it must be replaced prior to operation. Only use the replacement hose assembly specified by the manufacturer.
WARNING
• Perform all leak tests outdoors.
• Extinguish all open flames.
• NEVER leak test when smoking.
• Do not use heater until all connections
have been leak tested and show no
signs of leakage.
WARNING
For Outdoor Use Only
WARNING
CARBON MONOXIDE HAZARD
This appliance can produce carbon monoxide
which has no color. Using it in an enclosed
space can kill you. Never use this appliance in an
enclosed space such as a camper, tent or home.
Contact us for assistance: cservice@welltraveled.net