This is generally how your board should look after you finish it!
Note -
This version
with R3 and R4 is only
available on version V2
of the Muscle
SpikerShield
Page 1: ...s 5 Install two 1kΩ Resistors at R7 and R70 brown black red 6 Install one 390Ω Resistor at R5 orange white brown 7 Install one 33kΩ Resistor at R6 orange orange orange 8 Install four 10kΩ Resistors at R1 R2 R9 and R10 brown black orange 9 Install one 270kΩ Resistor at R8 red purple yellow 10 Install two 47kΩ Resistors at R14 and R15 yellow purple orange 11 Install one 100kΩ Resistor at R13 brown b...
Page 2: ...e top edge of the board From left to right install two red then two yellow then two green The longer leg of the LED goes in the hole closest to the top of the board and there is a flat part of the back of the LED that lines up with the marking on the board 28 Install chips in the chip holders Align the circle half circle mark on the chip toward the half circle on the end of the chip holder AD623 c...
Page 3: ...ield does not fill every single header on the Arduino Note SpikerShield board shown below is older model and may not be the exact one you have The orientation however is the same 2 Plug in your electrode cables and you are done To power the Arduino it needs to be plugged into a USB Power Source Visit the Experiments page on our backyardbrains com website to learn how to use your new tool for creat...
Page 4: ...This is generally how your board should look after you finish it Note This version with R3 and R4 is only available on version V2 of the Muscle SpikerShield ...
