INSTALLATION
WIRING
1.
Connect the sensor cables into the control module. The sensor ports on the module are
labeled A, B, C and D which corresponds to the sensors which are also marked A, B, C
and D. Please make sure to plug in the correct sensor to the corresponding sensor port.
(See FIGURE 10)
2.
Plug the buzzer cable into the DISP port on the control module.
(See FIGURE 10)
3.
For the power connector, connect the RED wire to the +12 volt reverse light wire of the
vehicle and connect the BLACK wire to chassis ground.
(See FIGURE 10)
RED
BLACK
Connect to
+12V Reverse
Light wire
Audible Buzzer
Chassis
Ground
Quick
Disconnect Plugs
CONTROL
BOX
S
E
N
S
O
R
S
A
B
C
D
A
B
C
D
NOTE:
On some vehicles, the reverse light system is part of a huge lighting circuit with many
other lights in the vehicle tied into the circuit. This can sometimes cause a back-feed into the
Backstopper system and cause false warnings making the system work incorrectly or not at all.
Please see our troubleshooting section for tips on how to solve this issue.
