Check again for leaks:
Re-inspect engine raw water cooling system for leaks.
Re-inspect engine fresh water cooling system for leaks.
Inspect exhaust system for leaks.
Re-inspect fuel system for leaks.
Re-inspect propeller shaft seal after 15-20 minutes of engine operation.
Stop engine. Follow procedures for stopping the engine in section 7.2 of this manual.
9. Sea Trials
Place on board all gear and registrations required by USCG and local laws. (See also
section 4.0 for general boat safety.)
Run for at least 30 minutes at various speeds up to full speed.
Do not exceed 1500 RPM until the engine cooling temperature reaches value specified in
owner’s manual.
Check for excessive vibration.
Check all systems for leaks.
Observe and record the following:
WOT RPM (no load): ________________________________________________
WOT RPM (under load): _____________________________________________
Idle RPM: _________________________________________________________
Seconds to boost: __________________________________________________
Seconds to plane: __________________________________________________
Percentage of engine load at WOT: _____________________________________
When these checks are completed, return to dock and stop engine.
10. Compensate Compasses
Note:
This should be performed by a qualified technician, and may require an additional fee to
the owner.
11. 120V AC Systems
Connect the shore power cord(s).
Select “SHORE” as the power source(s). Check polarity and voltage.
Check function of each branch circuit breaker.
The water heater must be full before turning “ON” its branch circuit breaker. See
instructions under “Fresh Water System”.
Page 6 of 10
Summary of Contents for Back Cove 30
Page 1: ...Back Cove 30 Owner s Manual...
Page 30: ...5 0 V e s s e l O v e r v i e w 5 1 General Arrangement Cockpit Helm Deck Cabin...
Page 35: ...5 3 Mechanical Overview Lazarette Engine Room Forward Bilge Zone...
Page 61: ...Fig_6 12c 7 Fig_6 12c 8 Companionway Fig_6 12c 9 Mate Seat Footrests Companionway Catch s...
