MAC2000
Initial Set-Up
2 Initial
Set-Up
2.1 Initial Set-Up Instructions
WARNING
It is extremely important to follow these instructions! Improper
setup will result in potential inaccuracies when operating the unit.
1.
Un-box the MAC2000.
2.
Open the accessory box that contains the rear and side tray mats,
the high- and low-side service hoses, the snap-shot transmitter,
and one spare printer paper roll.
3.
Drop the mats into the side and rear storage trays.
4.
Attach the blue low-side service hose to the service-hose fitting
with the blue label, and attach the red high-side service hose to the
red service fitting.
5.
Attach the snap-shot transmitter to its magnetic storage plate.
6.
Install an external source tank of R-134a refrigerant on the lower
shelf of the unit, below the handle. The external source tank
should be
inverted
so liquid refrigerant is supplied to the internal
tank. The MAC2000 can handle 30 lb (14kg) or 50 lb (23kg)
commercial tanks. Secure the tank to the unit by placing the strap
around the tank and tightening it.
WARNING: Failure to
secure the source tank properly could result in injury!
Instruction 2072-0400
9
Summary of Contents for 2072-0400
