BAC SP2A series, Rigging And Installation Instructions

Page: 2 / 26

About Rigging and Installation
The BAC equipment should be rigged and installed as outlined in this bulletin.
These procedures should be thoroughly reviewed prior to the rigging and operation to acquaint all personnel with
the procedures to be followed and to assure that all necessary equipment will be available at the jobsite.
Be sure to have a copy of the unit certified drawing available for reference. If you do not have a copy of this drawing
or if you need additional information about this unit, contact the local BAC Balticare representative. His name and
phone number can be found on the BAC website: www.BaltimoreAircoil.eu or www.BaltimoreAircoil.co.za. The
model type and serial number of your equipment are indicated on the unit nameplate.
Recommended Maintenance and
Monitoring Programme
Checks and Adjustments Start-Up Every
Month
Every 3
Months
Every 6
Months
Every Start of Adiabatic
Season, Spring
Adiabatic Pre-Cooler water flow X X X
Tighten Electrical Connections X X X
Rotation of fan(s) X
Motor voltage and current X X X
Unusual noise and/or vibration X X X
Inspections and Monitoring Start-Up Every
Month
Every 3
Months
Every 6
Months
Every Start of Adiabatic
Season, Spring
General condition of the equipment X X X
Adiabatic pre-cooling pads X X X
Heat transfer coil X X
Water distribution pipe X X X
City water strainer X X X
Cleaning Procedures Start-Up Every
Month
Every 3
Months
Every 6
Months
Every Start of Adiabatic
Season, Spring
Adiabatic Pre-Cooling media X X X
Adiabatic gutter system X X
Auxiliary equipment integrated in the cooling system may require additions to the table above. Contact
suppliers for recommended actions and their required frequency.
W W W . B A L T I M O R E A I R C O I L . C O . Z A
2