7
8
ASSEMBLY
ASSEMBLY
Copyright © 2021, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Copyright © 2021, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
• Line up the front fender and press onto
the front frame assembly (Fig. 5c).
• Insert the 4 screws through the
underside of the front frame assembly
into the front fender’s plastic tubes.
Tighten the screws only until snug
(Fig. 5d).
DO NOT OVER TIGHTEN.
REAR WHEEL
6)
• Lean the stroller forward to rest on the
front wheel. To attach the rear wheels,
push each wheel’s axle into the plastic
corner fitting (Fig. 6). Depress the metal
lever on the inside of the corner fitting
as you push the axle into corner fitting.
When the wheel will not go on any
farther, release the lever.
NOTE:
Check that the rear wheels have
locked into the corner fitting by pulling
on the wheels. If not locked, lift upward
on the levers, push the wheels in farther
and release the levers. This should allow
the rear wheels to lock into the corner
fitting.
• Ensure that the wheels are firmly
locked into place.
NEVER
use the
stroller if the wheels are not locked into
place, contact our customer service
department immediately at 1-800- 328-
7363, between the hours of 8:00am and
4:30pm PST, for assistance.
Fig. 6
PARENT TRAY
WARNING:
Do
not place hot liquids or
more than 3 pounds in the
parent tray. Serious burns or
unstable conditions could
result.
7)
• To attach the parent tray, position the
parent tray in the center of the stroller
handle.
• Snap the upper portion of the tray over
the handle (Fig. 7a).
• Attach the lower portion of the parent
tray to the cross tube, with the screws
provided (Fig. 7b).
CANOPY
8)
•
To open the canopy:
push forward
on the front edge of the canopy. Fully
adjust and extend the canopy and
smooth out the fabric along the canopy
framing
(Fig. 8).
9)
•
To fold the canopy:
pull backwards on
the front edge (Fig. 9).
Fig. 5c
Fig. 5d
Fig. 7a
Snap
Fig. 7b
Insert screws
Open
Fig. 8
Lever
