BabySafe ES09, Instruction Manual

Page: 27 / 60

7
dsfdsdfs
Loosen the shoulder belts by pressing the quick adjuster button, (A1)
and pulling the shoulder belts towards you (A2).
Release the belt buckle and drape the belts with the tongue sections over the two
side of the seat.(B)and pull the buckle forward, attach the loop of the belt pad over
the edge of the quick adjuster button.
Make sure there are no toys or other hard objects in the shell.
Position your baby comfortably in the baby car seat.
Join the buckle tongue sections together and insert them into the buckle (until it
clicks) (C).
Pull the shoulder belts tight using the quick adjuster belt strap on the front
Adjusting the height of the shoulder belts
The shoulder belts should run through the slots located directly above the
baby s shoulders.
• Pull the shoulder belts through the slots in the shell and cover.
• Place the shoulder belts back, at the required height and use.
• the same slots in both the shell and the cover.
• Check to make sure the belts can be used properly and that they are not twisted.
IMPORTANT!
The more tightly the belts are fastened around the child, the better the
protection. You should be able to fit no more than one finger between the belts
and your child.
The belts should never be twisted or damaged.
When positioning the baby make sure that he/she does not sit on the
belts by hanging them to the side behind the belt hooks. Hook the belt pad of the
belt that goes between the legs behind the edge of the quick adjuster.
If you are unable to fasten the harness belts properly or pull them tightly,
contact your supplier immediately. Do not use the baby car seat under
any circumstances!
B. Removable seat insert
The baby car seat has a removable seat insert (E) to creat a flater lying position for
newborn babies and support the head in a sideways direction. When the baby is
(approx 4 or 5 months) remove the filling block (F) to make the seat deeper, then
you can still use the head support.
PLACING YOUR CHILD IN THE BABY CAR SEAT