9
SIMPLY CARE
• Instruction manual
A / Transmitter
• Switch the transmitter on by setting button
(2)
to VOX
(tripped on voice, recommended) or to ON (continuous
operation). The power on indicator
(1)
will light up
green.
• Select either channel 1 or 2 using the Channel Selector
Switch
(3)
.
• Place the transmitter about 1 m from the cradle,
directing the microphone
(6)
towards the baby.
• Under VOX mode, once the built-in microphone
picks up any sound from the baby, the transmitter
will automatically switches into transmit mode and the
transmit indicator
(4)
lights up. When the baby stop
making sound, the transmitter will return to standby
mode and the transmit indicator goes off.
• Under ON (continuous transmission) mode, the
transmitter will always transmit no matter the baby
is making any sound or not. This is useful if you
want to monitor the slightest sound of the baby. For
conventional supervision, you are advised to use the
“VOX” mode.
• The condition of the batteries is shown by the indicator
(1)
. When the batteries are flat, the intensity fades and
becomes red.
B / Receiver
• Set the power ON/OFF switch
(9)
to ON position to turn
on the unit. The power on indicator
(7)
will light up green.
• Select the same channel as the emitter using knob
(10)
.
• Place the receiver at a reasonable distance away from the
transmitter to avoid feedback. Too close a distance will
create a screeching sound.
• Once the unit receives a signal from the transmitter, the
LED of the visual level meter
(11)
light up. The louder the
baby’s voice, the more number of LED will be lighted up.
This feature is useful in case the parents prefer to turn
down the speaker volume to keep the environment quiet
while still able to monitor the activity of baby.
• The condition of the batteries is shown by the indicator
(7)
. When the batteries are flat, the intensity fades and
becomes red.
N.B.:
If you hear noises other than your baby’s, change
to another channel both for the transmitter and receiver.
• For more convenience, the receiver can be carried around
using the belt clip.
OPERATION
Problem
Possible cause
Solution
No transmission from
the transmitter.
• The batteries have run out.
• Install new batteries.
Transmits without interruption.
• The transmitter is set in
continuous transmission mode.
• Switch the Power/VOX/ON
(2)
knob to VOX position or place
the transmitter further away from
the baby.
A lot of static and interference.
• The transmitter is located close
to other electrical apparatus.
• Remove the electrical appliances
away from the source of interfe-
rence or change the channel.
Too short communication range.
• A large number of steel
structures between the
transmitter and the receiver.
• The batteries have run out.
• Reposition the transmitter and the
receiver.
• Replace the batteries.
IN CASE OF PROBLEMS
∙ Frequency: 863 MHz - 865 MHz
∙ Maximum output power: 7.418 dBm (ERP)
∙ Battery: 3 x AAA 1,5 V (transmitter) + 3 x AAA 1,5 V (receiver)
