04
3. TO FIT AND REMOVE THE FRONT WHEELS
A.
Take each front swivel wheel assembly and press it
into each of the front leg mouldings. To assist with
assembly, press down the swivel release button.
B.
To remove the swivel wheels, simply push down on
the swivel release button.
4. TO USE THE SWIVEL WHEELS
A.
Lift the locking clip up to release the swivel wheels.
B.
Push down on the locking clip to lock the wheels in the
trailing position. The swivel wheels will lock when they
have returned to the trailing mode.
NOTE -
Always lock the swivel wheels when using the stroller
on rough or uneven surfaces. It will minimise wheel wobble.
5. TO FIT AND REMOVE THE REAR WHEELS
A.
Insert each wheel axle into the moulding and push in
until locked. You should hear an audible click noise.
Pull on the wheel to make sure it is engaged. Repeat
process if not locked in.
B.
To remove wheels if necessary, locate the release clip
under the wheel housing. Press down on the clip and
pull the wheel/s off.
www.babylove.com.au
A
B
09
www.babylove.com.au
HELPFUL HINTS
If the wheels squeak - use a silicon based spray or light oil ensuring it penetrates the
wheel and axle assembly.
When using your stroller at the beach - completely clean your stroller afterwards to
remove the sand and salt from the mechanisms and wheel assembly.
If there are compression marks on the tyres - use a domestic hair dryer to gently warm
the tyre and the compression marks should slowly disappear. (DO NOT OVERHEAT).
DO NOT DRY CLEAN, OR USE BLEACH.
Do not machine wash, tumble or spin dry, unless the care labelling on the product
permits these methods.
Non removable fabric covers and trims may be cleaned using a damp sponge with soap
or mild detergent. Allow it to dry completely before folding or storing it away.
In some climates the covers and trims may be affected by mould and mildew. To help
prevent this occurring, do not fold or store the product if it is damp or wet. Always store
the product in a well ventilated area.
Always check parts regularly for tightness of screws, nuts and other fasteners - tighten if
required. To maintain the safety of your nursery product, seek prompt repairs for bent,
torn, worn or broken parts. Use only those parts and accessories approved by Britax.
THIS PRODUCT IS NOT INTENDED FOR COMMERCIAL USE.
