BaBylissPro 4rtists LO-PRO FX825E, Manual, Page: 8 / 124

8
power cord around the appliance.
HOW TO USE COMB ATTACH-
MENTS
To use the comb attachments,
turn the clipper to the «0» (OFF)
position. Slide the comb attach-
ment onto the top of the clipper
blade, and then pull down and
over the back of the blade. To
remove, pull up on the back of the
comb attachment and then pull
away from the blade.
Fig. 2
REPLACEMENT (REMOVAL) OF
BLADE SET
Step 1. Unplug the unit and adjust
the taper (see position in illustra-
tion A).
Taper
A. B.
Small
Moving
Blade
Plastic Oscillator
Step 2. Remove the screws and the
fixed blade. Save the screws.
Step 3. Lift off the small moving
blade and replace it with the new
one on the plastic oscillator (see
illustration B).
Step 4. Replace the fixed blade
using the screws and lightly tigh-
ten them. Adjust the teeth, as
shown in illustration C, to a gap
of 1 mm to 1.5 mm. The small, mo-
ving blade should be as centered
and as parallel as possible to the
fixed blade’s teeth.
IMPORTANT NOTE:
The top edge of the fixed blade
must be a minimum of 1 mm
higher than the top edge of the
moving blade and as centered as
possible. This is important so that
the moving blade does not come
in contact with the skin.
Be sure to add a few drops of
BaBylissPRO lubricating oil to the
blades before running the clipper.
Don’t forget to tighten the screws
after the blades have been alig-
ned.
BLADE SHARPENING
BaBylissPRO cutting blades are
ground from the finest quality gra-
phite and are hardened to extend
the cutting performance. As with
any cutting appliance, the cutting
edges become dull from repea-
ted use. Increasing blade tension
to force the blade cutting would
cause the clipper to overheat
and reduce its motor life. When
the blade is no longer able to cut
smoothly, sharpening is required
or replace it with a new BaByliss-
PRO blade set.
C.
Small
Moving
Blade
Fixe Blade
1 to 1.5mm
C.
ADJUSTABLE TAPER LEVER
The taper lever is positioned at
your thumb. You can hold the