BaBylissMEN SUPER CLIPPER XTP, Manual, Page: 6 / 12

Left and Right Ear Taper Guides
The taper guides can be used above the ear to get a clean line.
• Attach either the left or right guide depending on which ear you are
cutting above.
• Angle the clipper and gently stroke around the ear towards the back
of the neck.
Taper Control
The taper control lever enables fine cut adjustment for precision
clipping.
• To increase the cutting length, push the lever down.
• To reduce the cutting length, push the lever up.
Charging the Appliance
• Before using the appliance for the first time, charge the battery
continuously for 2 hours even if you wish to use it from the mains.
Maximum battery capacity will only be reached after 3 completed
charging and discharging cycles.
• Plug the charging adapter into a suitable mains power socket and
switch on at the wall. A blue LED light will flash slowly and continuously
to indicate the clipper is charging. When the battery is fully charged
the LED light will stop flashing and will remain alight.
• A 2 hour charge will provide 85 minutes use. A 30 minute quick
charge will provide approximately 30 minutes use.
NOTE: Do not charge the appliance for longer than the recommended
time.
• When the clipper is running low on charge, the LED indicator light
will flash, warning you there is approximately 3 minutes left of battery
use remaining.
• If the charging light starts to flash rapidly (more than 4 flashes per
second) then the appliance is faulty. If this happens then please stop
charging and remove the adapter from the mains and contact the
Conair Customer Care Line. (See ‘UK After Sales Service’ section for
further information).