BaBylissMEN 7700U, Manual

Page: 5 / 12

Taper Control
The taper control lever enables fine cut adjustment for precision clipping.
The blade cutting length without a comb guide is 0.8mm.
• To increase the cutting length, push the lever down.
• Each position will increase the length as below:
• Taper position 1 - + 0.0mm
• Taper position 2 - + 0.2mm
• Taper position 3 - + 0.3mm
• Taper position 4 - + 0.5mm
• Taper position 5 - + 0.6mm
Charging the Appliance
• Before using the appliance for the first time, charge the battery
continuously for 3 hours. Maximum battery capacity will only be reached
after 3 completed charging and discharging cycles.
• Plug the charging adapter into a suitable mains power socket and
switch on at the wall. A blue LED light will continuously run up the
product to indicate the clipper is charging. When the battery is fully
charged the LED light will stop running up the product and all 5
charging lights will remain alight.
Note: Always place the clipper in the base with the ‘I/0’ switch in the
OFF position.
• When the clipper is running low on charge, the bottom LED charging
light will flash to warn there is approximately 5 minutes of battery use
remaining. A 3 hour charge will provide 3 hours use. A 20 minute quick
charge will provide approximately 20 minutes use.
• If all five charging lights start to flash rapidly (more than 4 flashes per
second) then the appliance is faulty. If this happens then please stop
charging and remove the adapter from the mains and contact the Conair
Customer Care Line. (See ‘UK After Sales Service’ section for further
information).