supplying the bathroom. Ask your installer for advice.
•
WARNING!
Do not use this appliance near bathtubs,
showers, basins or other vessels containing water.
• Do not immerse the appliance into water or other liquids.
• Always inspect the appliance before use for noticeable
signs of damage. Do not use if damaged, or if the
appliance has been dropped. In the event of damage,
discontinue use immediately. Contact the Conair
Customer Care Line (refer to ‘UK After Sales Service’
section for further information).
• Do not use the appliance if the lead is damaged. In the
event of damage, discontinue use immediately. If the lead
is damaged it must be replaced by the manufacturer.
Return the appliance to the Customer Care Centre (refer
to ‘UK After Sales Service’ section for further information).
No repair must be attempted by the consumer.
• Do not leave the appliance unattended when switched
on or plugged in.
• This appliance is equipped with a safety thermostat. In
the event of overheating the appliance will either stop
automatically or run hot and cold intermittently. Should
this happen, switch the appliance to the ‘0’ position,
unplug and allow to cool for 10 minutes. Before use,
ensure the rear filter is clear of hair and other debris. Plug
in and switch on. If the appliance continues to overheat
discontinue use immediately, switch off and unplug, and
contact the Conair Customer Care Line (refer to ‘UK
After Sales Service’ section for further information).
