INSTRUCTIONS FOR USE
• Ensure hair is dry and combed through to remove any tangles.
Divide the hair into sections ready for styling.
• Push the ‘ON’ button and wait for approximately 5 seconds.
• Press the ‘START’ button on the handle of the appliance several
times.
• The light at the end of the barrel should now be on and the tong
should begin to heat up.
• Wait for 1 minute, the appliance is now ready for use.
• Pressing the lever, place the appliance midway up a section of
hair and spread hair evenly between the lever and barrel.
• Once hair is in place carefully let go of the lever so the hair is
held securely between lever and barrel. Gently slide the appliance
down to the hair ends.
• Wind the hair around the barrel at a slight angle, so the hair wraps
around the barrel in a spiral motion. As you wind the hair around
the barrel, ensure the hair is distributed evenly so the entire
section is touching the barrel, try not to overlay the hair.
• Hold in place for 5-8 seconds depending on the texture and
length of your hair.
• To remove the appliance from the hair, press the lever and pull
appliance away.
• Allow the curl to cool before styling.
• Repeat on each hair section.
• After use, push the ‘OFF’ button and replace the protective heat
shield.
• Allow to cool before storing away.
Brush Attachment
• Use the brush attachment to add root volume and shape to styles.
• Make sure the barrel is cool and slide the brush attachment over
the barrel until it clicks into place.
• To remove the brush attachment, firstly make sure the barrel is
completely cool, then press the black ridged button, located on
the bottom of the brush attachment.
