sides of your head to the back.
• You should achieve an even length cut all over your head.
For a shorter back and sides, with length on the top:
•
Attach the longer comb guide as required for the top of your
hair – your clipper is supplied with 8 comb guides (grades 1-8). Each
comb guide is labelled.
• Switch the clipper on and the blades will start to move.
• Hold the clipper to the front of your hair with the teeth pointing
towards the back of your head and move the clipper towards your
crown. Repeat as necessary, moving in rows from the front and the
sides of your head to the back.
• If you then wish to take the back and sides of your hair to a shorter
length, switch off the appliance and attach a shorter comb guide.
• Starting at the nape of the neck, with the comb guide flat against
the head, move the clipper upwards and outwards over the area you
want to take shorter.
• Repeat on the sides of the hair, starting with the teeth of the clipper
pointing upwards and comb guide flat against the area above the ear,
again moving the clipper upwards and outwards.
Outlining:
• To tidy up the edges around your cut e.g. neckline and sideburns,
detach the comb guides.
• Hold the appliance upside down, so the front of the clipper is facing
towards your head.
• Hold the clipper straight on your sideburns or neckline and move the
clipper downwards. This will give you a clean, smooth finish.
Cleaning & Maintenance
To maintain optimum performance, the appliance should be cleaned
after each use:
• Remove the comb guide - the comb guides can be rinsed under
running water. Please make sure they are dried thoroughly before
storage or further use.
• Using the cleaning brush, brush and blow away any remaining hair
from the blades.
• Do not disassemble the blades.
Summary of Contents for Super Clipper XTP
Page 1: ...Model 7475RU ...
Page 12: ...Updated 150506 ...
