•
Once the appliance is fully charged, unplug the adaptor from the
mains socket and appliance and prepare for use.
Oiling Instructions
IMPORTANT!
It is highly recommended before each use to oil the
blades with the oil provided. This ensures optimum cutting performance.
For the first use you will need to use the oil supplied with the product,
unscrew the cap and cut off the very end of the plastic tube with a
pair of scissors to release the oil. To oil the blades ensure the unit is
switched on. Gently squeeze the oil tube and apply 2 drops of oil onto
the blades. Leave the unit on for a further few seconds to allow the oil
to thoroughly spread the length of the blades. Switch off the unit and
remove any excess oil by gently dabbing with a cloth.
Preparation for Use
• Always inspect the appliance before use for noticeable signs of
damage. Do not use if damaged.
• Ensure the blades are free from hair and debris and that they are
properly oiled (refer to the ‘Oiling Instructions’ for further information).
• Ensure the appliance is sufficiently charged.
• Use on clean, dry hair that has been combed until tangle free.
Using the Length Control Dial
The length control dial allows you to adjust the comb guide to change
the cutting length of your trimmer. You’ll need to experiment to find
your preferred length, but as a guide, 1mm will give you a very short be
a stubble beard and 12mm with be thicker and longer.
• Select a cutting length (1-12mm) using the dial on the front of the
trimmer. Turning the dial clockwise will increase the cutting length.
Turning it anti-clockwise will decrease the cutting length.
•
Once you have selected your desired cutting length, the guide
automatically locks into position for a guaranteed, even cut.
• Switch the trimmer on by sliding the power button up, the blades will
start to move and you can begin trimming.
7860U IB-18/079.indd 6
5/25/18 5:45 PM
