Assembly
A: Rear wheel assembly
Installing the rear wheel 1:
Insert the rear end of the shaft into the rear wheel, put a nut
at the end and then put the back shaft into the frame beam.
Installing the rear wheel 2:
Insert the rear end of the shaft through another rear wheel,
cover with a nut, and tighten with wrench on both ends of
the rear axle. Fix the rear wheel cover.
Installing the mudguard and the handle:
Fix the front fork with the mudgaurd, put the spring on the
top of the fork, insert the front fork into the front of the
frame, Insert the handle bar and x it with screws.
Please note: Since the spring is used for fastening, while the
handle is installed, the frame should be pressed down so
that the hole on the front fork and the hole in the tap can be
accessed for the screw.
Installing the front wheel:
Place the plastic pieces on both sides of
the front wheel on the front fork and fasten with screws.
Installing the seat:
Place the seat on the seat plate, and x the screws at the
bottom.
Installing the push handle 1:
Remove the bush on the pipe of the handle, insert the lower
part of the push handle from the bottom, up to the handle
pipe of the frame, Cover the middle of the handle with the
HAFU and then set the middle of the handle to the lower
part of the push handle.
Installing the push handle 2:
After aligning the two screw holes in the middle part of the
push handle and the lower part of the push handle,put the
screw then lock on. Screw the plastic nut on the HAFA.
Installing the push handle 3:
Put the quick release screw on the middle of the handle, cover the upper part of the handle, then lock the quick
release screw.
Installing the steering wire:
The front end of the steering
wire is inserted into the hole
in the front of the frame,with
a nut lock, insert the back end
into the hole in the iron plate
of the lower part of the push
handle and lock it with a nut.
Installation completed