Warning
1. The BABYHUG HIGH RAISE CAR BOOSTER SEAT unit is suitable for children weighing 15-
36KG(33-79lbs).
2. The device is only suitable if the approved vehicles are ted with 3 point safety-belts,
approved to UN/ECE Regulation No. 16 or other equivalent standards.
3. Please place it forward-facing. DO NOT put them in the front passenger seat if there is a
passenger air bag.
4. Any straps holding the restraint to the vehicle should be tight, that any straps restraining
the child should be adjusted to the child's body, and that straps should not be twisted.
5. Ensuring that any lap strap is worn low down, so that the pelvis is rmly engage , shall
be stressed.
6. DO NOT leave the buckle in a partially closed position and it must only lock when all the
parts are engaged. It must possible to release the child from restraint immediately in an
emergency.
7. The device should be changed when it has been subject to violent stresses in an
accident.
8. Do not make any alternations or additions to the device without the approval of the
manufacturer. It is dangerous if not following closely the installation instructions provided
by the child restraint manufacturer.
9. The child restrain should be kept away from sunlight when it is not provided with the
textile cover, otherwise it may be too hot for the child's skin.
10. Children are not left in their child restraint system unattended.
11. Any luggage or other objects liable to cause injuries in the event of a collision shall be
properly secured.
12. The child restraint must not be used without the cover.
13. The seat cover should not be replaced with any other than the one recommended by
the manufacturer, because the cover constitutes an integral part of the restraint
performance.
14. Do not use any load bearing contact points other than those described in the
instruction and marked in the child restraint.
Installation Methods:
1. Put the seat on the car, close to the seat belt.
2. Put the child on the seat, and let him/her lie on seat back. Use the cummerbund through
increased the double handrail of the seat and x o the vehicle safety buckle, and then
tighten cummerbund. Do not wind knot seat belt. As below Picture.
14. Do not use any load bearing contact points other than those described in the
instruction and marked in the child restraint.
15. This child restraint can only be used in the car, not for home.
16. DO NOT put objects in the child restraint, keep it away from corrosive material.
17. The manufacturer will guarantee the quality of the child car seat, but not the second-
hand seat.
3. To remove the child from the seat, as long as you can release the seat belt buckle.
