Step 2 -
Setting up your seat & canopy
To recline the seat, lift the
seat recline latch located
at the canopy end of the
frame and tilt the seat
forward or back.
Note: The seat can be
faced in the forward or
rear facing position.
• This stroller seats one passenger with a maximum weight limit of 20kg.
• Not suitable for a child under 6 months old who cannot sit up unaided.
• Do not allow your child to climb unassisted into the stroller.
• Maximum weight for the seat pocket is 1kg.
Line up the seat
connectors with the frame
and press downwards.
Listen for the ‘click’ and
ensure it is securely
locked in place.
Refer to page 12 for instructions on
adjusting your harness.
click!
1
2
• Please ensure that your child correctly wears the fitted and adjusted safety
harness at all times with all 5 straps secured.
• Never leave the harness buckled when not fitted to the child in the stroller.
The harness can form loops which may cause a strangulation hazard.
TIP: Your canopy visor may need a little TLC after shipping. To get it
looking nice and new again simply apply heat from a clothes steamer or
hair dryer to remove any wrinkles (just be careful not to scorch the fabric).
This is not covered under warranty.
To attach the canopy, first
secure it to the frame with the
zip starting from the left side
(when facing the seat).
3
Finally, insert the belly bar into
the belly bar sockets on the seat
frame. Always give the bar a firm
tug to ensure its secure.
Note: To remove from one side
or both, press the button on the
side you want to release, and
pull the belly bar out.
5
click!
Next attach the plastic
canopy connectors onto the
sides of the frame (TIP: attach
from top to bottom). You’ll notice
a round guide on each side, the
connectors should attach
over these guides.
click!
4
9
8
