Step
4
-
Setting up your seat & canopy
Line up the seat
connectors with the frame
and press downwards.
Listen for the ‘click’ and
ensure it is securely
locked in place.
To recline the seat, press
the large, round, buttons
on the sides of the seat
connectors and tilt the
seat forward or back.
To remove the seat press
the oval buttons on the
sides of the seat
connectors and lift up.
Note: The seat can be
faced in the forward or
rear facing position.
• This stroller seats
two
passenger
s
with a maximum weight limit of 20kg
each
.
• Not suitable for a child under 6 months old who cannot sit up unaided.
• Do not allow your child to climb unassisted into the stroller.
Refer to page 1
5
for instructions
on adjusting your harness.
click!
1
2
• Please ensure that your child correctly wears the fitted and adjusted safety
harness at all times with all 5 straps secured.
• Never leave the harness buckled when not fitted to the child in the stroller.
The harness can form loops which may cause a strangulation hazard.
TIP: Your canopy visor may need a little TLC after shipping. To get it
looking nice and new again simply apply heat from a clothes steamer or
hair dryer to remove any wrinkles (just be careful not to scorch the fabric).
This is not covered under warranty.
4
To secure the canopy, first
ensure that it is zipped onto the
seat.
Next attach the plastic
canopy connectors onto the
sides of the frame (TIP: attach
from top to bottom). You’ll notice
a round guide on each side, the
connectors should attach
over these guides.
Finally, insert the belly bar into
the belly bar sockets on the seat
frame. Always give the bar a firm
tug to ensure its secure.
Note: To remove from one side
or both, press the button on the
side you want to release, and
pull the belly bar out.
6
5
12
11
3
click!
click!
