A / C
FIGURE 02
ASSEMBLY INSTRUCTIONS
Thank you for choosing this quality product.
Be sure to check all packaging materials
carefully for small parts that may have
become loose during shipment and place all
parts on a non-abrasive surface.
The bed is composed of several components:
The headboard, side rails, foot board, bed
slats, support slat and leg. Determine the
intended location and ensure there is enough
space to work with and fully read these
instructions before physically doing the entire
assembly.
STEP #1:
Gently lay down the headboard (A) and
footboard (C) on a plain and non-abrasive
surface.
Note: on the bottom of both headboard (A)
and footboard (C) are holes with
pre-installed nuts that correspond to the
threaded rods pre-installed in the leg (E).
STEP #1.2
Align and insert the threaded rod of the leg
(E) into the hole and turn clockwise to
tighten as illustrated in FIGURE 01.
STEP #3:
Place the headboard (A) upright in the
position you wish the bed to be in when fully
assembled. The headboard bed fast hardware
should be facing the inside, toward the
mattress. Secure the threaded rods (1) to the
fixed nuts in the headboard (A) by simply
turning manually. Raise the side rail (B) up
and place the rods (1) to align with the bore
holes on the end of the side rails (B). Put the
side rails (B) up against the headboard (A) so
the threaded rods go through the bore holes.
Insert curved washers (2) and lock washers
(3), place hex nuts (4) on threaded rods (1)
and tighten hex nuts (4) with wrench (5), as
illustrated in FIGURE 02.
FIGURE 01
FIGURE 02
Page 2 of 3