Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.
Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.
7
8
SAFETY
SAFETY
safety by sliding buckles in either direction.
Safety straps are to fit snug around your child.
(Fig. 14)
• To release, push Red Button on Center Clasp,
the two Harness Buckles will pop free.
(Fig 15) This process requires a moderate
amount of effort so as to prevent an accidental
release by your child.
TRAVEL SYSTEM - Safety Belt
• Strap the safety belt over the infant car seat
through the seat belt slots on the infant car
seat, connect the buckles together (Fig. 16).
The safety belts for the infant car seat is
located in small pockets on outer sides of seat
pads. Tighten the strap so the infant car seat
fits snug and can't move.
IT IS VERY IMPORTANT THAT THE
INFANT CAR SEAT STRAP IS ALWAYS
TIGHTLY FASTENED AROUND THE
INFANT CAR SEAT.
JUMP SEAT - 3-Point Harness
• Secure the child with the jump seat 3-point
harness (Fig. 17) when child is sitting on the
jump seat.
PLATFORM - Safety Belt
• Secure the stand feature safety belt behind
child and engate buckle (Fig. 18). This is the
same safety belt you use to secure the rear
infant car seat.
TO RECLINE SEAT
FRONT SEAT
The front seat has a two position recline. To
recline the seat, rotate the recline bar and press
backward on the seat back. (Fig. 19) To place the
seat in the upright position, press upward on the
seat back while rotating the recline bar.
WARNING:
The upright
position should be used only for a
child that is at least 6 months old.
WARNING:
Avoid serious
injury from falling, ALWAYS use
the safety belt to secure the car seat.
Attach the infant car seat:
Position the Infant Car Seat facing toward the rear
of the stroller, so that the seat shell goes into the
front tray and latches into place. (Fig. 20)
Check that the Infant Car Seat is firmly locked
onto the front tray before using
.
Check that the infant car seat is firmly locked onto
the child tray then
STRAP THE SAFETY BELT
OVER THE CAR SEAT
through the seat belt
slots on the infant car seat, connect the buckles
together. (Fig. 21) Tighten the strap so the infant
car seat fits snug and can't move.
IT IS VERY IMPORTANT THAT THE INFANT
CAR SEAT STRAP IS ALWAYS TIGHTLY
FASTENED AROUND THE INFANT CAR
SEAT.
DO NOT USE INFANT CAR SEAT
WITHOUT THE SAFETY BELT.
Fig. 16
Fig. 17
Fig. 18
Fig. 19
Fig. 15
Center Clasp
Fig. 20
Locks
into tray
Fig. 21
