Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.
Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.
5
6
Fig. 8
REAR WHEEL
Lean the stroller forward to rest on the front
wheel. To attach the rear wheels, push each
wheel's axle into the plastic corner fitting as
shown in Fig. 8. Depress the metal lever on the
inside of the corner fitting as you push the axle
into corner fitting. When the wheel will not go
on any farther, release the lever. Check that the
wheel has locked into the corner fitting by pulling
on the wheel. If not locked, lift upward on the
lever, push the wheel on farther and release lever.
Ensure that the wheels are firmly locked
into place.
NEVER
use the stroller if the
wheels are not locked into place, contact our
customer service department immediately at
1-800- 328-7363, between the hours of 8:00am
and 4:30pm PST, for assistance.
PARENT TRAY
To attach the parent tray, align the fittings on the
ends of the parent tray with the fittings on the
outsides of the handle. Hook the hole in the parent
tray. Pull outward on the opposite end while
pushing down on the tray until locked onto the
stroller handle. Please be careful not to pinch your
fingers when installing the parent tray. (Fig. 9) To
remove the parent tray, pull outward on one end of
the tray while lifting upward.
WARNING:
Do not place
hot liquids or more than 3 pounds
in the parent tray. Serious burns or
unstable conditions could result.
CANOPY
To open the canopy: push forward on the front
edge. (Fig. 10a)
To fold the canopy: pull backwards on the front
edge. (Fig. 10b)
ASSEMBLY
CHILD TRAY
To attach the child tray:
Push the angled side of the tray onto the post
at the end of the right armrest while pressing
downward on the snap button, until locking in
place. (Fig. 11) Rotate the tray downward until it
latches onto the left armrest into place. (Fig. 12)
Note: Check that the snap button comes through
and securely in place.
WARNING:
The child’s
tray is not a restraint device:
always secure your child with the
seat belt. DO NOT lift the stroller
by the child’s tray. Use care when
attaching the child’s tray on the
stroller with a child in the stroller.
To access the child seat:
Press the red snap button on the right side and lift
upward. The child tray will lift and rotate out of
the way to allow access to the seat. (Fig. 13)
To remove the child tray:
Press the red snap button and rotate the tray
upward, then release the snap button located on
the underside of the right armrest and pull the tray
until it released. (Fig. 14)
INFANT CAR SEAT
(if equipped)
To attach the Baby Trend Infant Car Seat, recline
the seat all the way back.
WARNING:
Never jog or
run with your newborn in the car
seat position. Use for strolling only.
• Position the Infant Car Seat, facing toward the
rear of the stroller, so that the seat shell goes
into the front tray and latches into place. (Fig.
15)
Check that the Infant Car Seat is firmly
locked onto the front tray before using.
ASSEMBLY
Fig. 9
Fig. 10a
Fig. 10b
Open
Close
Fig. 11
Fig. 12
Fig. 13
Fig. 15
Fig. 14
