37
38
9. Check that the base is tightly installed and
stays tightly installed by grasping the base
near the belt path and trying to move side-to-
side. If LATCH belt loosens or that the or the
base does not stay tightly secured, please see
Section 8.0 Selecting the Best Location for
the Car Seat to determine if the position you
have selected is adequate and check that you have completed all of
the steps in the section entitled Securing the Car Seat or Base in the
Vehicle. DO NOT use this seating location if the Car Seat does not
remain tightly installed in the vehicle seat!
10.2.3 To Remove Base
Disconnect LATCH Lower Connectors.
To disconnect the LATCH Connectors:
1. Push base toward LATCH connectors and
while pushing on the base, press the RED
LATCH Release Button in the base belt
path (Fig 37-2).
2. Press the RED LATCH Release Button on
one of the LATCH Connectors (Fig 37-3)
and pull base away from the
vehicle anchors.
3. Repeat on opposite side.
4. Return LATCH connectors to storage
position on side of base.
5. Pull downward on LATCH belt end loops to
remove excess belt from LATCH system.
10.3 Base Installation with Vehicle Belt
WARNING!
DEATH or SERIOUS INJURY can occur:
• VEHICLE LAP BELT MUST BE TIGHTLY ADJUSTED AND STAY TIGHTLY
ADJUSTED AROUND CHILD RESTRAINT AT ALL TIMES. IF VEHICLE
BELT DOES NOT STAY TIGHT, READ VEHICLE OWNER’S MANUAL AND
“VEHICLE SEAT BELT REQUIREMENTS” SECTION IN THIS MANUAL.
• PROPER RECLINE ANGLE FOR SEAT BACK RECLINE IS REQUIRED.
FOLLOW THE INSTRUCTIONS FOR ADJUSTING RECLINE ANGLE
USING SEAT ANGLE INDICATOR.
- TOO UPRIGHT CAN CAUSE A YOUNG INFANT’S HEAD
TO FALL FORWARD AND RESTRICT BREATHING.
- TOO RECLINED CAN CAUSE EJECTION IN A SUDDEN STOP
OR CRASH.
37-3
37-2
LATCH Release
Button
37-1
10.0
Securing Car Seat in Your Vehicle
10.0
Securing Car Seat in Your Vehicle
