Copyright © 2007 - 2010, Baby Trend Inc., All Rights Reserved.
Copyright © 2007 - 2010, Baby Trend Inc., All Rights Reserved.
11
12
ASSEMBLY
ASSEMBLY
(a)
(b)
(c)
Fig. 24
Fig. 25
Fig. 26
WARNING
FALL HAZARD:
To
prevent death or serious injury,
always keep child within arm's
reach.
Always use restraint belt to prevent
falls, see page 12 for details.
Contents:
(a) 2 Long Curved Bars
(b) 2 Short Bar with Connector Knobs
(c) 1 Changing Table
ATTENTION:
Playard must be fully assembled and securely
locked before installing or using the changing
table feature. (See To Assemble Playard section)
1. Connect the two (2) Long Curved Bars
together (Fig. 24).
2. Insert the assembled curved bars into the
Changing Table fabric (Fig. 25) Slide the
Curved Bars around inside sleeve of the
Changing Table.
3. Connect the two (2) Short Bars to each end
of the Long Curved Bar (Fig. 26) Make sure
that the knobs are both facing down and the
same direction on each end. (Fig. 27)
Fig. 27
TO ASSEMBLE CHANGING TABLE
Fig. 28
Fig. 29
Fig. 31
Fig. 30
Fig. 32
Fig. 33
4. Insert Connector Knob Prongs into holes
located on both corners of the Playard
(Fig. 28).
5. Turn the Connector Knobs counter clockwise
to lock into place (Fig. 29).
6. Flip Changing Table over onto Playard
(Fig. 30).
7. Snap the two (2) buttons on the flap down
onto the Playard (Fig. 31).
IMPORTANT:
Check that the Changing Table
is correctly and securely installed BEFORE
each use.
To use changing table
restraint system
1. Place child on changing table, make sure hand
and arms are clear of the restraint. Bring the
restraint around the child's waist and clip the male
and female ends of the buckle together. (Fig. 32)
2. Tighten strap until fits snug around child's
waist.
DO NOT OVER TIGHTEN
. (Fig. 33)
3. To remove, unsnap the buckle.
ATTENTION:
NEVER
use changing table if it is damaged or
broken.
