Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.
Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.
3
4
ASSEMBLY
ASSEMBLY
IMPORTANT!
To ensure safe operation of your stroller,
please follow these instructions carefully. Please keep these
instructions for future reference.
IMPORTANT!
Before assembly and each use, inspect this
product for damaged hardware, loose joints, missing parts or sharp
edges. NEVER use if any parts are mssing or broken.
IMPORTANT!
Adult assembly is required.
FRONT WHEELS / SUSPENSION
To attach the front wheels:
• Lift up on the stroller handle with both hands
until the stroller frame is erect and locked in
the open position. (Fig. 1)
• Lean the stroller backwards so that it rests on
the handle and rear axle frame and the front
wheel forks are pointing upward.
• The front wheels feature a quick release
attachment system. The quick release must be
open enough for the wheel to slide on the forks.
Rotate the lever forward to loosen one side
(Fig. 2a) and loosen the finger nut on the other
side. (Fig. 2b)
• Slide the front wheel onto the front forks.
(Fig. 3a) Make sure the front forks are in the
position as shown on Fig. 3b.
• Line up the tab on the Retainer Plate with the
Slot on both sides of the forks. (Fig. 3c)
IMPORTANT!
The tab on the Retainer Plate
must be lined up with the slot before tightening
the wheel.
• With the wheel in position, tighten the
finger nut on the axle until it is very close
to contacting the fork and rotate the lever to
tighten it as shown in Fig. 4.
Suspension is featured on this model. To ensure a
smooth ride check suspension from time to time,
make sure it is working properly.
Close
Open
Fig. 5
Fig. 7a
Fig. 7b
Fig. 7c
Fig. 7d
Fig. 6
Tighten
Loosen
Fig. 4
• Close the lever (Fig. 5) and you should feel
significant resistance and the wheel should be
held tightly. If you do not, open the lever and
tighten the finger nut a bit more and close the
lever again. Continue to do this until the wheel
is held tightly in the fork.
DO NOT OVER TIGHTEN
.
WARNING:
Always make
sure the lever is in closed postion
before use. Leaving the lever in
opened postion can cause the wheel
to fall off.
• If you experience front wheel wobble that is
beyond what is normal for use while walking
or jogging you may have to adjust the front
wheel housing nut. This nut is located under
the footrest located at the front of the jogger.
You can use a standard cresent wrench to
tighten the nut.
DO NOT OVER TIGHTEN
this can cause
damage to the wheel housing. (Fig. 6)
FENDER
To secure the fender to the frame, use the 4 screws
provided.
• Examine the bottom of the front fender. You
will notice four 1/4 inch diameter plastic tubes
protruding from the bottom (Fig. 7a).
•These tubes must be lined up with the holes in
the front frame assembly (Fig. 7b).
•Line up the front fender and press onto the
front frame assembly (Fig. 7c).
•Insert the 4 screws through the underside of
the front frame assembly into the front fender's
plastic tubes. Tighten the screws only until
snug (Fig. 7d).
DO NOT OVER TIGHTEN
.
Fig. 1
Fig. 2b
Loosen
Fig. 2a
Fig. 3a
Fig. 3b
Lever
Slot
Retainer Plate
Fork Plate
Ring
Fig. 3c
