background image

Failure  to  properly  adjust  the  harness  on  your  child 
increases the risk of death or serious injury in the event of 
a  sharp  turn,  sudden  stop  or  crash.    Please  follow  the 
instructions  very  closely  to  ensure  that  the  harness  is 
properly  adjusted  to  fit  your  child  at  all  times.    Your  child 
will grow very rapidly!  Please check the fit of the harness 
every time you use the Safety Seat.

9) Use of the Safety Seat with the Base:

9.1)

 Squeeze the Base Release handle, located 

below the foot end of the Safety Seat, to 

release the Safety Seat from the Base.

Please see figure 28-1.

9.2)

 To attach the Safety Seat to the Base, align 

the Safety seat with the Base and push down 

until the Safety Seat latches onto the Base.

Check that both sides of the Safety Seat are 

securely attached to the base.

10) Operation of the Carry Handle

10.1)

 The Carry Handle has three positions: the 

upright carry position, a mid-storage 

position, and the non-rocking position.

10.2)

 Depress the two buttons located on the 

handle just above the connection to the 

Safety Seat shell to release the handle.

10.3)

 Slowly rotate the handle to the desired 

position.  The buttons should pop out and 

the handle should automatically lock into 

the new position.

10.4)

 Before lifting the Safety Seat, push on the 

handle to check that both sides of the 

handle have locked into place.

10.5)

 Use the Mid Storage or non-rocking 

position when the Safety seat is the vehicle.

11) Attaching the Canopy

11.1)

 Slip the canopy stays through the 

sleeves on the canopy.

11.2)

 The canopy is attached by inserting the 

ends of the canopy plastic stays into the 

female fittings found on the inside of 

the handle hub.

12) Adjustment of the Shoulder Straps.

12.1)

 Adjustable Back Safety Seat

 12.1.1)

 The Adjustable Back Safety Seat includes a 

sliding back component that will adjust the height 

of the harness straps as the back is adjusted.

 12.1.2)

 To adjust the seat back height, turn the moving 

back adjuster knob behind the seat clockwise to 

increase the seat back height and counter 

clockwise to decrease the seat back height. Each 

half turn will raise or lower the slots 1/2".

12.1.3)

 The proper height of the harness straps is even 

with or just below your child's shoulders.

12.1.4)

Remove the Safety Seat from the Base and rotate 

the Carry Handle to the non rocking position.  

Place your child in the Safety Seat such that your 

child's bottom is all the way to the rear and bottom 

of the seat. (See Fig. 32-1)  Rotate the knob behind 

the seat back to raise or lower the moving seat back 

and harness straps.  Knob must remain in vertical 

position after adjustment. (Fig. 31-1)  The Harness 

Straps must be even with or just below the child's 

shoulders. (Fig. 31-2)  

DO NOT

 use the Safety 

Seat with the Harness adjusted above the child's 

shoulders as the child will not be held securely in a 

sharp turn, sudden stop, or crash.

Mid Storage in

vehicle position

Non Rocking in

vehicle position

Upright Carry

Rotate the Handle

Proper height is even 

or just below shoulder

Fig. 31-2

Fig. 31-1

Knob handle must 

be vertical

Squeeze

Fig. 28-1

31

30

29

28

Summary of Contents for FLEX-LOC
















Reviews: