41
42
10.4 Attach Car Seat to Base
1. Remove any toy or other objects attached to carry handle
before installing car seat in vehicle.
2. Check that nothing is on top of the base or anything that will
interfere with the proper latching of the Car Seat to the Base.
3. Place the Car Seat onto the Base and push down until the
Car Seat locks securely to the Base and you hear a click.
(Fig 42-1)
4. Pull upward on the Car Seat to check that the Car Seat is
securely locked onto the base. If the Car Seat does not
securely lock onto the Base, the Car Seat will provide NO
Protection for your child. DO NOT use the Car Seat with the
Base if it does not securely lock onto the Base. Please call
Baby Trend at 1-800-328-7363 for assistance.
5. Check that car seat is in the correct recline position based
on the weight of your child. See (Fig 42-2) and Section 11.4
Adjusting Seat Recline Angle
.
6. Check that toys are removed from carry handle, and then
adjust handle into the STORAGE position. When this car
seat is used with a base, the carry handle must be in the
STORAGE position (Fig. 42.3).
10.5 Removing Car Seat from Base
1. To remove from base, raise handle to the carry position,
squeeze the base release handle located below the foot
end of the Car Seat (Fig 42-4).
10.0
Securing Car Seat in Your Vehicle
10.0
Securing Car Seat in Your Vehicle
3. Tighten the vehicle lap belt around the Base by pushing down hard
with your hand or knee in the middle of the Base. Then pull the
vehicle seat belt to tighten.
Note: For more information on how to tighten the belt for your
vehicle seat belt system, see Section 8.0 Selecting A Vehicle Seat
Location
and Section 9.1 SAFE Seat Belt Systems, or your vehicle
owner’s manual.
4. Check that the base is tightly installed and stays tightly installed by
grasping the base near the belt path and trying to move side-to-side.
Base should not move more than 1 inch (2.54 cm). If you find that
the vehicle seat belt loosens or that the or the base does not stay
tightly secured, please see Section 8.0 Selecting A Vehicle Seat
Location
for the Car Seat to determine if the
position you have selected is adequate and
check that you have completed all of the steps
in this section. If vehicle belt does not stay
tightly adjusted around base, see vehicle seat
belts section. A locking clip may be needed or
you may need to move the base to a different seating location. DO
NOT use this seating location if the Car Seat does not remain tightly
installed in the vehicle seat!
10.3.5 To Remove Base
1. Unbuckle vehicle seat belt.
2. Remove lap belt from Vehicle Belt Path openings.
3. Remove Base.
42-4
42-2
42-3
42-1
10 kg
under
10 to
14.5 kg
(22 to 32 lbs./livres)
(22 lbs./livres) and
