![background image](http://html1.mh-extra.com/html/baby-lock/tiara-ii-bltr16-2/tiara-ii-bltr16-2_instruction-and-reference-manual_462517014.webp)
Babylock.com
Page 13
Setting Up the Table (and Taking it
Down for Storage)
Check that the On/Off switch (page 12, Figure 3, # 25) is
turned off (the 0 setting). Plug the power cord into the
top power outlet on the back of the machine (Figure 4).
Do not plug the power cord into an electrical outlet at
this time.
The accessory power connector (page 12, Figure 3, #27)
is available for powering future attachments as they are
developed by manufacturer. (Not yet available.)
Installing the Power Cord
1. Plug in the foot pedal cord end into the foot pedal con-
nector (see page 12, Figure 3, # 28).
2. Place the foot pedal under the table where operator
can reach it from the front of the machine.
The Baby Lock Tiara II table has been designed to accom-
modate the Baby Lock Tiara II machine. It has folding
legs that are height-adjustable and is heavy enough to
provide stabilization for quilting at high speeds.
1. Open the box and gently remove the table, taking care
not to drop the table on the floor. The table weighs
over 50 pounds, so it is recommended that you ask
someone for assistance.
2. Remove shipping brace from underneath quilting table
by removing the two bolts holding it in place.
3. Unfold the legs by pulling on the horizontal braces,
while being careful not to pinch fingers, until the legs
snap into place.
4. Make the table taller by pinching the two height-
adjustment tabs on each set of legs and lifting on table,
while holding legs down with your foot. Make the table
shorter by pinching the same tabs and pushing down
on the table.
5. To store the table, remove machine and return legs to
their lowest position.
6. The legs are attached to the table top with brackets of
two different sizes. One is longer than the other. Iden-
tify the long and the short leg brackets.
7. Fold in the short bracket leg first. Push on the hori-
zontal braces to loosen the legs and push them back
toward the table top.
8. Repeat with the long bracket leg.
Installing the Foot Pedal
Placing the Machine in the Table
1. We recommend having someone help lift and place the
machine into the table..
2. Lift the machine by putting one arm through the
throat space.
3. Guide the machine from the back of the table into the
slot. Machine is positioned correctly when the back of
the machine is flush with the back of the table.
Figure 4
Figure 3