11
EN
G
LIS
H
j
Turn the handwheel toward you
(counterclockwise) to feed the needle into the
fabric or punched hole. Position the upper
thread over the presser foot and lightly hold
then, lower the presser foot lever.
a
Punched hole
b
Upper thread over the presser foot
k
Pulling the upper thread gently, turn the
handwheel toward you (counterclockwise)
until the mark on the handwheel aligns with
the center top of machine.
→
A loop of the bobbin thread comes out through the
hole in the fabric.
l
Raise the presser foot lever, and then use
tweezers to pull up the bobbin thread and
bring the end of the thread to the top of the
fabric.
m
Align the upper thread and bobbin thread,
and then pass them under the presser foot
toward the rear of the machine.
n
While gently holding threads at the rear of the
machine, turn the handwheel to feed the
needle into the fabric or punched hole again,
and then lower the presser foot lever.
o
Press
at lower right of LCD screen.
→
All keys and operation buttons are unlocked, and
the previous screen is displayed.
p
Select a low speed , gently hold the threads
behind the presser foot and start sewing.
Threads can be released after several stitches
have been made.
q
When you have reached the end of the
stitching area, stop the machine.
Note
• If the bobbin thread does not come up, hold the
upper thread as shown below to pull up the bobbin
thread.
a
Upper thread
Note
• Pull the thread while holding down the fabric so it
does not move out of place.
Note
• Before sewing, check that there is enough thread in
the bobbin.
Note
• Do not sew reinforcement/reverse stitches at the
end of the stitching, otherwise the threads may
become tangled or the needle may break. In
addition, it will be difficult to pull the bobbin thread
up to the wrong side of the fabric.
