![background image](http://html1.mh-extra.com/html/baby-lock/crown-jewel-iii-blcj18-3/crown-jewel-iii-blcj18-3_instruction-and-reference-manual_462379016.webp)
15
Installing Machine
on Carriage
1.
Place the carriage on the table rails ensuring that the carriage
stitch regulator assembly is toward the back of the table (
Figure 1)
.
2.
The stitch regulator, machine and carriage are connected by
a ribbon cable that has 3 connectors (
Figure 2
). The machine
should arrive from the factory with the ribbon cable already at-
tached by Connectors A and B. The remaining end, Connector
C, will be connected in Step 4.
Figure 1
Back of
table
Carriage
Stitch
Regulator
Assembly
(X-Motion)
Front of
table
Figure 3
Figure 2
C
B
A
IMPORTANT NOTE:
Very carefully remove the plastic wire
tie securing the Carriage Stitch Regulator Assembly (X-
Motion)
after
the carriage is placed onto the tracks of the
quilting frame.
NOTE:
Connector A is a serial port connector and connects at
position 33 as shown in (
Rear Diagram C, #34, page 14
). Con-
nector B connects to the machine stitch regulator assembly
(Y-Motion) shown in (
Back-Side Diagram B, #27, page 14)
, as
well as (
Figure 3
). If these two connections have come loose in
shipping, reconnect them before proceeding to step 3.
3.
Place the machine on the carriage, with the front of the machine
toward the front of the table and all wheels on the carriage rails.
4.
Plug final ribbon cable Connector
C
into the carriage stitch
regulator assembly (
Figure 1
).
Stitch Regulator (Y-Motion)
Summary of Contents for Crown Jewel III BLCJ18-3
Page 1: ...3 ...