![background image](http://html1.mh-extra.com/html/baby-lock/celebrate-bls1/celebrate-bls1_instruction-and-reference-manual_3275767024.webp)
Re-threading Needles
Re-threading Loopers
If a thread breaks, raise the presser foot and pull the broken thread out from under the foot. Open
the front cover, depress the machine lock button, rotate the machine hand wheel slowly toward
you until the tubes move to their connecting position, and set the looper threader selector to U or
L for the looper being threaded. Re-thread the machine above the threading port, leaving an
18-inch (45cm) thread tail. Thread the looper as usual and move the lock button release lever to
the right. Close the front cover and sew a test sample. Refer to page 15-16 for further
information.
Note:
When re-threading your Baby Lock Celebrate using the "Jet-Air Threading" feature, make
sure that the previous thread that was in the looper (tube) is completely removed. This will
eliminate any chance of the previous thread obstructing the flow of the air when re-threading the
machine.
If a needle thread breaks, raise the presser foot, remove the broken thread and rethread the
needle thread guides. Turn the handwheel and line up the green marks on the handwheel and
machine. Select the "R" or "L" for the needle being rethreaded. Use the needle threader for
exact and easier threading. Refer to pages 17-18 for further information.
T
H
R
E
A
D
I
N
G
21
Summary of Contents for Celebrate BLS1
Page 1: ...TM Model BLS1...
Page 5: ...N O T E S 2 Notes...