Regalia Stationary User Manual | 15
Installation and Setup
Installing the Power Cord
Check that the On/Off switch is turned off
(the 0 setting). Plug the power cord into the
side power outlet on the back of the machine.
Do not plug the power cord into a power
source at this time.
The top power connector is available for
powering future attachments (not available
at this time) as they are developed by Baby
Lock.
Installing the Foot Pedal
1. Plug in the foot pedal cord end into the foot pedal connector that is attached to
the table.
2. Place the foot pedal under the table at the front, under the machine, for easy
operation.
Installing the Thread Mast
1. Locate the two small M4x10mm hex button head screws and the thread mast
assembly.
2. Align the screws in the thread mast
bracket with the two holes in the
side of the machine (top tension
side). Use a 2.5mm hex tool to
tighten the bracket firmly to the
side of the machine.