![background image](http://html1.mh-extra.com/html/baby-lock/blkf/blkf_assembly-instructions-manual_462357018.webp)
18 Baby Lock Kinetic Frame Assembly Instructions
Step 8
Ratchet Stop Assembly
8-3: Following the parts order shown in
Fig. 8-1, thread one M6 x 48mm QF09318-204
through a ratchet-stop, ratchet-stop bushing,
pole bracket (with ratchet-stop holder inserted)
and finally into the ratchet-stop mount. Pay
close attention to the orientation of the ratchet-
stop. Tighten with the 4mm Allen wrench
until the ratchet-stop-holder nub holds the
ratchet-stop.
8-4: In same manner, attach the remaining
ratchet-stops and ratchet-stop catches to the
front of the pole bracket, paying attention to
the orientation of the ratchet-stops (Figure
8-1, Details 8-1a, Details 8-1b and 8-1c)
to create the right pole bracket.
Parts needed
(1) open-hole pole bracket (right)
(3) M6x48mm socketed washer head
cap screw QF09318-204
(3) ratchet-stop
(3) ratchet-stop bushing
(3) ratchet-stop mount
(3) ratchet-stop holder
Tools Required
4mm Allen wrench (provided)
8-1: Identify the open-hole pole bracket
(right bracket) and the plugged-hole pole
bracket (left bracket). Set the plugged-hole
pole bracket aside at this time. (Fig. 8-1)
8-2: Place one ratchet-stop catch between the
two metal pieces at the back of the open-hole
pole bracket, with the stop nub facing inside,
as shown in Fig. 8-1 and Details 8-1a,
8-1b, and 8-1c found on the next page. If the
ratchet-stop holder will not fit, loosen the two
bearing screws nearest the square hole. Slide
in the ratchet-stop holder and re-tighten
when finished.
Fig. 8-1
QF09318-204 Screw
Stop
Bushing
Holder
Mount
Summary of Contents for BLKF
Page 1: ......