i
String tensioning
Once the racket has been properly installed and the clamps adjusted, refer to the stringing
recommendations of the racket manufacturer and enter the tension value of the string
(
TENSION
) on the control panel.
¾
To tension the string, pass it around the
diabolo and then close the pulling unit by
pulling the string towards you while lightly
touching the "start cycle" button.
¾
When the required tension is reached, close
the 3-tooth clamp and lock the clamp-holder
so as to hold the string firm. Lightly touch
the "cycle start" button again. The traction
head will return to its initial position and the
pulling unit will open up and release the
string.
When the traction head arrives at its end of
travel without the tension being reached, the
buzzer goes off to indicate that the tension is not
correct.
To obtain the additional tension (
KNOT
), press
the "SHIFT" key when the string is tensioned.
Clamp-holding system
With the clamp-holder you can easily position the
3-tooth clamp at any point on the racket by
sliding it over the elliptic turntable.
¾
In order to keep the string pulled, you
should:
- slide the clamp-holder over the turntable to
position it under the string that you wish to
keep pulled,
- tighten the string using the locking lever of
the 3-tooth clamp (
1
),
- lock the clamp-holder on the turntable by
activating the locking knob (
2
).
BE CAREFUL:
use very little force on the knob
as the materials used provide a
very high locking capacity.
¾
To unlock the clamp-holder, loosen the
clamp-holder locking knob, raise the clamp
locking lever and move the clamp-holder
away.
12
1
2
