Gas Fired Tandoor Instruction Manual
Manual Rev. May 2016
Page | 7
•
It is required that the Tandoor be interlocked to the hood ventilation system.
•
There must be sufficient low- level ventilation to ensure that the appliance has a
good supply of clean fresh air.
3.4.
Gas supply and connection
•
Check that the gas supply correspondence to that on data plate. Gas connection
must be the same size of the Baba Clay Oven, BSP ½”, (For U. S. A. and Canada NPT
½”). Inlets. Warning
: Do not under any circumstances join NPT to BSP threads when
making connections.
•
The ½” connection for connection of gas supply is located behind the unit.
•
A shut off valve should be installed on the gas service line ahead of the unit in case
of emergency and for serving purposes. The location of the manual shutoff valve
should comply with codes in effect at the installation site.
•
Since the appliance is caster mounted, connection of the appliance must be made
using suitable flexible connection devices
. Ensure that the hose is suitable for
commercial catering appliances and a restraining wire and wiring label are used.
•
Fixed pipe work must not be used with this appliance.
•
For the U. S. A. and Canada - Installation shall be made with a connector that
complies with the standard for connectors for Movable Gas Appliance, ANSI Z21.69-
CSA 6.16, and a quick Disconnect devices for the use with gas fuel, ANSI Z21.41- CSA
6.9.
•
For the U.S.A and Canada
–
Included in the Tandoor kit is a gas pressure regulator,
compliant to ANSI Z21.18 and CSA 6.3, which will need to be connected between
the gas supply line and the Tandoor. Installation instructions are included with the
unit. WARNING: Service and installation of the unit must be performed by a
trained/experienced technician.
•
Connect tandoor to gas supply and conduct gas leakage tests to verify gastight
connections. Check entire piping system for leaks. A solution consisting of 50%
dishwashing detergent and water mix can be applied to all piping parts with a brush.
•
Matches, candles or other sources with open flames or sparks shall not be used for
this purpose. Gas controls are provided with outlet settings suitable for the fuel type
shown on the name plate. Adjustments, if needed, to the regulator should only be
made by qualified service staff. The regulator outlet pressure must be the pressure
shown on the name plate for the type of gas fuel used.
•
Some local codes require that a manual shutoff valve be installed in the same room
and within six feet of the appliance. If because of local code requirements, a manual
gas shutoff valve has to be installed on the appliance, and if it is mounted inside of
enclosure by access doors, a label should be provided indicating this construction.
