Update Tool V3
Documentation
EIBPORT Version 3 Update Procedure
1
EIBPORT VERSION 3 UPDATE PROCEDURE
You will find a description of the update procedure additionally in the top part of the update tool. The
LED codes are also mentioned there.
UPDATE PREPARATIONS
The EIBPORT must be in the same subnet as the pc from which the update will be done. Remote
updates are not possible!
Create a backup
from your current project. With the firmware update the
complete project data is been deleted. After it the EIBPORT is in factory default.
INSTALL NEW FIRMWARE
The selected EIBPORT is red framed when chosen. On the left side the update user interface is shown.
Please fill in the authentication data, choose the desired firmware image and then click on „Start
EIBPORT
Update “
.
Figure1: EIBPORT Update Tool
Reset network settings
If you wish that the EIBPORT
is available with default network settings after the update the flag “Reset
network” must be enabled. Then the
EIBPORT is available within the IP-address 192.168.1.222 and http
port 80. If the EIBPORT should keep its current IP-address this option should be leaved disabled.
The firmware image is loaded into the EIBPORT and is then been verified. In the status window the
details about the update progress are shown. It is been ended
with the message „Upload finished
successfully “
. Then a dialogue comes up:
Note: After the update, the EIBPORT is back in its factory settings. Except for the network
settings, all settings are reset. The network settings are only reset if the corresponding flag (see
figure above) is set. After the update, you must log in again with the logon data of the delivery
Status. User: admin; Password: eibPort
